Gerstmann, U., Vollmers, N. J., Lücke, A., Babilon, M., &; Schmidt, W. G. (2014). Rashba splitting and relativistic energy shifts in In/Si(111) nanowires. Physical Review B, 89(16).https://doi.org/10.1103/physrevb.89.165431 

Li, Y., Schmidt, W. G., &; Sanna, S. (2014). IntrinsicLiNbO3point defects from hybrid density functional calculations. Physical Review B, 89(9).https://doi.org/10.1103/physrevb.89.094111 

Sanna, S., Hölscher, R., &; Schmidt, W. G. (2014). Temperature dependent LiNbO3(0001): Surface reconstruction and surface charge. Applied Surface Science, 70–78.https://doi.org/10.1016/j.apsusc.2014.01.104 

Sanna, S., Schmidt, W. G., Rode, S., Klassen, S., &; Kühnle, A. (2014). Unraveling theLiNbO3X-cut surface by atomic force microscopy and density functional theory. Physical Review B, 89(7).https://doi.org/10.1103/physrevb.89.075403 

Beister, F., Dräxler, M., Aelken, J., &; Karl, H. (2014). Power model design for ICT systems – A generic approach. Computer Communications, 50, 77–85.https://doi.org/10.1016/j.comcom.2014.02.007 

Wessel, J., Schmalz, K., Cahill, B., &; Scheytt, C. (2014). Design of an Electrical Interferometer at 120 GHz for Contactless Permittivity Characterization. Elektrotechnisches Kolloquium.

Mischkalla, F., &; Müller, W. (2014). Architectural Low-Power Design Using Transaction-Based System Modeling and Simulation. Embedded Computer Systems: Architectures, Modeling, and Simulation (SAMOS XIV).https://doi.org/10.1109/SAMOS.2014.6893219 

Wessel, J., Schmalz, K., Scheytt, C., &; Meliani, C. (2014).https://doi.org/10.1109/MWSYM.2014.6848446__Switchable slow wave transmission line in 130 nm SiGe technology at 115 GHz for phase detection based biosensors. Microwave Symposium (IMS), 2014 IEEE MTT-S International, 1–3.https://doi.org/10.1109/MWSYM.2014.6848446 

Wessel, J., Schmalz, K., Scheytt, C., Meliani, C., &; Cahill, B. (2014). A 7 GHz biosensor for permittivity change with enhanced sensitivity through phase compensation. European Microwave Conference (EuMC), 44th, 699–702.https://doi.org/10.1109/EuMC.2014.6986530 

Kraemer, R., Wolf, A., Scheytt, C., Kallfass, I., &; KrishneGowda, K. (2014). Wireless 100 Gb/s: PHY layer Overview and Challenges in THz freqency band. 2014 IEEE 15th Annual IEEE Wireless and Microwave Technology Conference (WAMICON).https://doi.org/10.1109/WAMICON.2014.6857743 

Koppelmann, B., Messidat, B., Becker, M., Kuznik, C., Müller, W., &; Scheytt, C. (2014). Fast and Open Virtual Platforms for TriCore-based SoCs Using QEMU. Design and Verification Conference (DVCON EUROPE).

Kuznik, C., &; Müller, W. (2014). Verific-MM: Systematized Verification Metrics Generation with UCIS for Improved Automation on Verification Closure. Design, Automation and Test in Europe DATE, University Booth, Dresden.

Scheytt, C. (2014). System-on-Chip Design für Funkfrequenzen oberhalb von 100 GHz-Herausforderungen und potenzielle Anwendungen. Analog 2014,14. Fachtagung Der Gesellschaft Für Mikroelektronik, Mikrosystemtechnik Und Feinwerktechnik Des VDE Und VDI.

Elkhouly, M., Mao, Y., Meliani, C., Scheytt, C., &; Ellinger, F. (2014). A -Band Four-Element Butler Matrix in 0.13 µm SiGe BiCMOS Technology. IEEE JOURNAL OF SOLID-STATE CIRCUITS, 49(9).

Oetjens, J.-H., Becker, M., Kuznik, C., Müller, W., Bannow, N., Brinkmann, O., Burger, A., Chaari, M., Chakraborty, S., Drechsler, R., Ecker, W., Grüttner, K., Kruse, T., Le, H. M., Mauderer, M., Mueller-Gritschneider, D., Poppen, F., Post, H., Reiter, Se.,https://doi.org/10.1145/2593069.2602976__Viehl, A. (2014). Safety Evaluation of Automotive Electronics Using Virtual Prototypes: State of the Art and Research Challenges. Design Automation Conference (DAC).https://doi.org/10.1145/2593069.2602976 

Ficara, E. (2014). Logik und Metaphysik. Hegel – 200 Jahre Wissenschaft der Logik. Deutsches Jahrbuch für Philosophie, 5, 245–256.

Ficara, E. (2014). Hegel on the Mathematical Infinite. Siegener Beiträge Zur Geschichte Und Philosophie Der Mathematik, 4.

Ficara, E. (2014). Hegel’s Glutty Negation . History and Philosophy of Logic , 36(1), 29–38.

Wallscheid, O., Huber, T., Peters, W., &; Böcker, J. (2014). Real-time capable methods to determine the magnet temperature of permanent magnet synchronous motors—A review. IECON 2014-40th Annual Conference of the IEEE Industrial Electronics Society, 811–818.

Specht, A., Wallscheid, O., &; Böcker, J. (2014). Determination of rotor temperature for an interior permanent magnet synchronous machine using a precise flux observer. 2014 International Power Electronics Conference (IPEC-Hiroshima 2014-ECCE ASIA), 1501–1507.

Mayrhofer, T., &; Schmitz, H. (2014). Testing the relationship between income inequality and life expectancy: A simple correction for the aggregation effect when using aggregated data. Journal of Population Economics, 27(3), 841–856.https://doi.org/10.1007/s00148-013-0483-7 

Keese, M., &; Schmitz, H. (2014). Broke, ill, and obese: is there an effect of household debt on health? Review of Income and Wealth, 60(3), 525–541.https://doi.org/10.1111/roiw.12002 

Kopetsch, T., &; Schmitz, H. (2014). Regional variation in the utilisation of ambulatory services in Germany. Health Economics, 23(12), 1481–1492.https://doi.org/10.1002/hec.3001 

Schafmeister, F., Ide, P., &; Richter, J. (2014). Adaptable AC Input Phase Switching for Optimum Utilization of Various Grid Configurations supplying Power Electronic Converters and EV/HEV On Board Chargers. Proc. IEEE International Exhibition and Conference for Power Electronics, Intelligent Motion, Renewable Energy and Energy Management (PCIM).  IEEE International Exhibition and Conference for Power Electronics, Intelligent Motion, Renewable Energy and Energy Management (PCIM 14), Nuremberg, Germany.

Li, R., Njiende, H., Schafmeister, F., &; Ide, P. (2014). A Soft-Switching Interleaved DC-DC Converter with Integrated Magnetics for High Voltage Battery Charger. Proc. IEEE International Exhibition and Conference for Power Electronics, Intelligent Motion, Renewable Energy and Energy Management (PCIM). IEEE International Exhibition and Conference for Power Electronics, Intelligent Motion, Renewable Energy and Energy Management (PCIM 14), Nuremberg, Germany.

Schafmeister, F., Hufnagel, M., &; Ide, P. (2014). Resistorless Precharging of Boost PFCs by Phase Angle Control of Thyristors. Proc. IEEE International Exhibition and Conference for Power Electronics, Intelligent Motion, Renewable Energy and Energy Management (PCIM).  IEEE International Exhibition and Conference for Power Electronics, Intelligent Motion, Renewable Energy and Energy Management (PCIM 14), Nuremberg, Germany.

Henke, C., &; Trächtler, A. (2014). Autonomously driven railway cabin convoys — Communication, control design and experimentation. 2013 International Conference on Connected Vehicles and Expo (ICCVE).https://doi.org/10.1109/iccve.2013.6799806 

Peters, W., &; Böcker, J. (2014). Discrete-time design of adaptive current controller for interior permanent magnet synchronous motors (IPMSM) with high magnetic saturation. IECON 2013 - 39th Annual Conference of the IEEE Industrial Electronics Society.https://doi.org/10.1109/iecon.2013.6700225 

Buchholz, O., &; Böcker, J. (2014). FPGA-based dynamically reconfigurable control of induction motor drives. IECON 2013 - 39th Annual Conference of the IEEE Industrial Electronics Society.https://doi.org/10.1109/iecon.2013.6699698 

Huber, T., Peters, W., &; Böcker, J. (2014). Monitoring critical temperatures in permanent magnet synchronous motors using low-order thermal models. 2014 International Power Electronics Conference (IPEC-Hiroshima 2014 - ECCE ASIA).https://doi.org/10.1109/ipec.2014.6869785 

Leuer, M., &; Böcker, J. (2014). Real-time implementation of an online Model Predictive Control for IPMSM using parallel computing on FPGA. 2014 International Power Electronics Conference (IPEC-Hiroshima 2014 - ECCE ASIA).https://doi.org/10.1109/ipec.2014.6869605 

Leuer, M., Ruting, A., &; Böcker, J. (2014). Efficiency-optimized Model Predictive Torque Control for IPMSM. 2014 IEEE International Energy Conference (ENERGYCON).https://doi.org/10.1109/energycon.2014.6850398 

Buchholz, O., &; Böcker, J. (2014). FPGA-based dynamically reconfigurable control of induction motor drives. IECON 2013 - 39th Annual Conference of the IEEE Industrial Electronics Society.https://doi.org/10.1109/iecon.2013.6699698 

Vogt, T., Peters, A., Fröhleke, N., Böcker, J., &; Kempen, S. (2014). Power profile based selection and operation optimization of parallel-connected power converter combinations. 2014 International Power Electronics Conference (IPEC-Hiroshima 2014 - ECCE ASIA).https://doi.org/10.1109/ipec.2014.6870091 

Solanki, J., Fröhleke, N., Böcker, J., Duppe, G., Averberg, A., &; Wallmeier, P. (2014). Voltage sequence control based high-current rectifier system. 2014 IEEE Energy Conversion Congress and Exposition (ECCE).https://doi.org/10.1109/ecce.2014.6953958 

Solanki, J., Fröhleke, N., &; Böcker, J. (2014). A completely modular power converter for high-power high-current DC applications. IECON 2013 - 39th Annual Conference of the IEEE Industrial Electronics Society.https://doi.org/10.1109/iecon.2013.6699127 

Peckhaus, V. (2014). Das Erkenntnisproblem und die Mathematik. Zum Streit zwischen dem Marburger Neukantianismus und dem Neofriesianismus. In C. Krijnen &; K. W. Zeidler (Eds.), Wissenschaftsphilosophie im Neukantianismus. Ansätze – Kontroversen – Wirkungen (Vol. 32, pp. 233–253, Diskussion 254-257). Könighausen &; Neumann.

Peckhaus, V. (2014). Unsinn und Chance eines Fiktionalismus in der Logik. In M. Neuber (Ed.), Fiktion und Fiktionalismus. Beiträge zu Hans Vaihingers Philosophie des Als Ob (Vol. 33, pp. 91–106). Könighausen &; Neumann.

Peckhaus, V. (2014). Ernst Schröder on Pasigraphy (Dossier de la logique philosophique à la logique mathématique). Revue d’histoire Des Sciences, 67, 207–230.

Peckhaus, V. (Ed.). (2014). In memoriam Helmar Frank (Vol. 133).

Fischer, M., &; Schöppner, V. (2014). Effects of a mass finishing process on parts produced from Ultem 9085 by Fused Deposition Modeling. ANTEC, 2331–2336.

Bagsik, A., Josupeit, S., Schöppner, V., &; Klemp, E. (2014). Mechanical Analysis of Lightweight Constructions manufactured with Fused Deposition Modeling. 29th International Conference of the Polymer Processing Society, 29, 696–701.https://doi.org/10.1063/1.4873874 

Specht, A. (2014). Ermittlung der Rotortemperatur einer Synchronmaschine mit eingebetteten Permanentmagneten für einen automobilen Traktionsantrieb mittels Beobachter basierend auf elektrischen Größen.

Cao, Z. (2014). Model-Based Development of DC-DC Converters with Wide Operation Range and High Dynamics.

Hu, M. (2014). Modeling Optimization and Control Design for LCC Resonant Converter Applied in Very Low Frequency High Voltage Generator.

Pohlenz, D. (2014). Wirkungsgradoptimale Regelung eines elektrischen Fahrantriebes mit variabler Zwischenkreisspannung.

Grote, T. (2014). Digital Control for Interleaved Boost Power Factor Correction (PFC) Rectifiers.

Leuer, M. (2014). Modellprädiktive Regelung permanent erregter Synchronmotoren im Antriebsstrang von Automobilen.

Uebener, S. (2014). Evaluierung und Anwendung eines Emulators für elektrische Maschinen in der Entwicklung von Elektro- und Hybridfahrzeugen.

Schneider, T. (2014). Traktionsantrieb mit linearem geschalteten Reluktanzmotor für ein autonomes Bahnfahrzeug.