@article{62667,
  author       = {{Mohamed, Sayed R.E. and Mohammed, Ahmed S.A. and Metwalli, Ossama I. and El-Sayed, S. and Khabiri, Gomaa and Hassan, Abdelwahab and Yin, Kai and Abdellatif, Sameh O. and Lopez Salas, Nieves and Khalil, Ahmed S.G.}},
  issn         = {{0925-8388}},
  journal      = {{Journal of Alloys and Compounds}},
  publisher    = {{Elsevier BV}},
  title        = {{{Synergistic design of high-performance symmetric supercapacitor based on iron oxide nanoplatelets/COOH-MWCNTs heterostructures: DFT computation and experimental analysis}}},
  doi          = {{10.1016/j.jallcom.2024.174118}},
  volume       = {{987}},
  year         = {{2024}},
}

@article{62664,
  author       = {{Makinde, Wasiu Olakunle and Hassan, Mohsen A. and Pan, Ying and Guan, Guoqing and Lopez Salas, Nieves and Khalil, Ahmed S.G.}},
  issn         = {{0925-8388}},
  journal      = {{Journal of Alloys and Compounds}},
  publisher    = {{Elsevier BV}},
  title        = {{{Sulfur and nitrogen co-doping of peanut shell-derived biochar for sustainable supercapacitor applications}}},
  doi          = {{10.1016/j.jallcom.2024.174452}},
  volume       = {{991}},
  year         = {{2024}},
}

@article{59270,
  abstract     = {{Lithium niobate tantalate (LiNb1−xTaxO3, LNT) solid solutions offer exciting new possibilities for applications ranging from optics, piezotronics, and electronics beyond the capabilities of the widely used singular compounds of lithium niobate (LiNbO3, LN) or lithium tantalate (LiTaO3, LT). Crystal growth of homogeneous LNT single crystals by the Czochralski method is still challenging. One key aspect of homogeneous growth is the accurate knowledge of thermal conductivity through the crystal boule during the growth, which is central to control the crystal growth. Therefore, the temperature dependent thermal conductivity of pure LN, LT, and LNT solid solutions, as well as of selected doped LN and LT crystals (Mg, Zn) was investigated across the temperature range from 300 to 1300 K. The results that span across the whole composition range can directly be applied for optimizing growth conditions of both LNT solid solutions as well as doped and undoped LN and LT crystals.}},
  author       = {{Bashir, Umar and Rüsing, Michael and Klimm, Detlef and Blukis, Roberts and Koppitz, Boris and Eng, Lukas M. and Bickermann, Matthias and Ganschow, Steffen}},
  issn         = {{0925-8388}},
  journal      = {{Journal of Alloys and Compounds}},
  publisher    = {{Elsevier BV}},
  title        = {{{Thermal conductivity in solid solutions of lithium niobate tantalate single crystals from 300 K up to 1300 K}}},
  doi          = {{10.1016/j.jallcom.2024.176549}},
  volume       = {{1008}},
  year         = {{2024}},
}

@article{41514,
  author       = {{Krüger, Jan Tobias and Hoyer, Kay-Peter and Filor, Viviane and Pramanik, Sudipta and Kietzmann, Manfred and Meißner, Jessica and Schaper, Mirko}},
  issn         = {{0925-8388}},
  journal      = {{Journal of Alloys and Compounds}},
  keywords     = {{Materials Chemistry, Metals and Alloys, Mechanical Engineering, Mechanics of Materials}},
  publisher    = {{Elsevier BV}},
  title        = {{{Novel AgCa and AgCaLa alloys for Fe-based bioresorbable implants with adapted degradation}}},
  doi          = {{10.1016/j.jallcom.2021.159544}},
  volume       = {{871}},
  year         = {{2021}},
}

@article{24087,
  abstract     = {{Resorbable implants are highly beneficial to reduce patient burden since they need not be removed after a defined period. Currently, magnesium (Mg) and polymers are being applied as bioresorbable materials. However, for some applications the insufficient mechanical properties and high degradation rate of Mg cause the need for new materials. Iron (Fe)-based alloys are promising due to their biocompatibility and good mechanical properties, but their degradation rate is too low and needs to be adapted eg. via alloying with manganese (Mn). Besides, phases with high electrochemical potential lead to increased degradation of residual material with lower potential based on the galvanic coupling. Here, silver (Ag) is promising for the formation of such phases due to its high electrochemical potential (+0.8 V vs. SHE), immiscibility with Fe, biocompatibility, and anti-bacterial properties. Since remaining silver particles can lead to adverse consequences as thrombosis, these particles need to dissolve after the matrix material. Thus a silver alloy with high electrochemical potential, biocompatibility, and adjusted degradation behavior is required as an additive for iron-based bioresorbable materials. Several silver alloying systems are possible, but regarding the electrochemical potential and degradation behavior of binary alloys, calcium (Ca) and lanthanum (La) are best-suited considering their biocompatibility. Accordingly, this research addresses AgCa and AgCaLa alloys as additives for iron-based degradable materials with adapted degradation behavior.}},
  author       = {{Krüger, Jan Tobias and Hoyer, Kay-Peter and Filor, Viviane and Pramanik, Sudipta and Kietzmann, Manfred and Meißner, Jessica and Schaper, Mirko}},
  issn         = {{0925-8388}},
  journal      = {{Journal of Alloys and Compounds}},
  title        = {{{Novel AgCa and AgCaLa alloys for Fe-based bioresorbable implants with adapted degradation}}},
  doi          = {{10.1016/j.jallcom.2021.159544}},
  year         = {{2021}},
}

@article{46005,
  author       = {{Pan, Ying and Wan, Tao and Du, Haiwei and Qu, Bo and Wang, Danyang and Ha, Tae-Jun and Chu, Dewei}},
  issn         = {{0925-8388}},
  journal      = {{Journal of Alloys and Compounds}},
  keywords     = {{Materials Chemistry, Metals and Alloys, Mechanical Engineering, Mechanics of Materials}},
  pages        = {{496--503}},
  publisher    = {{Elsevier BV}},
  title        = {{{Mimicking synaptic plasticity and learning behaviours in solution processed SnO2 memristor}}},
  doi          = {{10.1016/j.jallcom.2018.05.092}},
  volume       = {{757}},
  year         = {{2018}},
}

@article{29682,
  author       = {{Hütten, A. and Schmalhorst, J. and Thomas, A. and Kämmerer, S. and Sacher, Marc and Ebke, D. and Liu, N.-N. and Kou, X. and Reiss, G.}},
  issn         = {{0925-8388}},
  journal      = {{Journal of Alloys and Compounds}},
  keywords     = {{Materials Chemistry, Metals and Alloys, Mechanical Engineering, Mechanics of Materials}},
  number       = {{1-2}},
  pages        = {{148--152}},
  publisher    = {{Elsevier BV}},
  title        = {{{Spin-electronic devices with half-metallic Heusler alloys}}},
  doi          = {{10.1016/j.jallcom.2005.12.106}},
  volume       = {{423}},
  year         = {{2006}},
}