@article{63436, author = {{de Souza, Sivoney Ferreira and Beresowski, Christina and Kosmella, Sabine and Ameixa, João and Pothineni, Bhanu Kiran and Keller, Adrian Clemens and Hartlieb, Matthias and Taubert, Andreas and Bald, Ilko}}, issn = {{2574-0970}}, journal = {{ACS Applied Nano Materials}}, publisher = {{American Chemical Society (ACS)}}, title = {{{Nanocellulose Membranes for Plasmon-Enhanced Removal of Organic Pollutants from Water}}}, doi = {{10.1021/acsanm.5c04857}}, year = {{2026}}, } @article{58612, author = {{Luis-Sunga, Maximina and González-Orive, Alejandro and Calderón, Juan Carlos and Gamba, Ilaria and Ródenas, Airán and de los Arcos de Pedro, Maria Teresa and Hernández-Creus, Alberto and Grundmeier, Guido and Pastor, Elena and García, Gonzalo}}, issn = {{2574-0970}}, journal = {{ACS Applied Nano Materials}}, title = {{{Nickel-Induced Reduced Graphene Oxide Nanoribbon Formation on Highly Ordered Pyrolytic Graphite for Electronic and Magnetic Applications}}}, doi = {{10.1021/acsanm.3c05949}}, year = {{2024}}, } @article{48013, author = {{Liu, Ping and Schumann, Nils and Abele, Fabian and Ren, Fazheng and Hanke, Marcel and Xin, Yang and Hartmann, Andreas and Schlierf, Michael and Keller, Adrian and Lin, Weilin and Zhang, Yixin}}, issn = {{2574-0970}}, journal = {{ACS Applied Nano Materials}}, keywords = {{General Materials Science}}, publisher = {{American Chemical Society (ACS)}}, title = {{{Thermophoretic Analysis of Biomolecules across the Nanoscales in Self-Assembled Polymeric Matrices}}}, doi = {{10.1021/acsanm.3c03623}}, year = {{2023}}, } @article{47985, abstract = {{Strongly charged head-to-head domain walls that are purposely engineered along the [110] crystallographic orientation into ferroelectric BaTiO3 single crystals have been proposed as intrinsically nanoscaled two-dimensional electron gases (2DEGs) because of their significant conductivity. Here, we quantify these 2DEG properties through dedicated Hall transport measurements in van der Pauw 4-point geometry, finding the electron mobility to reach around 400 cm2 (V s)^{−1}, while the two-dimensional charge density amounts to 7 × 103 cm^{–2}. We underline the necessity to take into account the thermal and geometrical misalignment offset voltages by evaluating the Hall resistance under magnetic field sweeps; otherwise, errors of several hundred percent in the derived transport parameters can occur.}}, author = {{Beccard, Henrik and Kirbus, Benjamin and Beyreuther, Elke and Rüsing, Michael and Bednyakov, Petr and Hlinka, Jiří and Eng, Lukas M.}}, issn = {{2574-0970}}, journal = {{ACS Applied Nano Materials}}, keywords = {{General Materials Science}}, number = {{7}}, pages = {{8717--8722}}, publisher = {{American Chemical Society (ACS)}}, title = {{{Nanoscale Conductive Sheets in Ferroelectric BaTiO3: Large Hall Electron Mobilities at Head-to-Head Domain Walls}}}, doi = {{10.1021/acsanm.2c01919}}, volume = {{5}}, year = {{2022}}, } @article{22640, author = {{Piskunen, Petteri and Shen, Boxuan and Keller, Adrian and Toppari, J. Jussi and Kostiainen, Mauri A. and Linko, Veikko}}, issn = {{2574-0970}}, journal = {{ACS Applied Nano Materials}}, pages = {{529--538}}, title = {{{Biotemplated Lithography of Inorganic Nanostructures (BLIN) for Versatile Patterning of Functional Materials}}}, doi = {{10.1021/acsanm.0c02849}}, volume = {{4}}, year = {{2021}}, } @article{22686, author = {{Meinderink, Dennis and Orive, Alejandro Gonzalez and Ewertowski, Simon and Giner, Ignacio and Grundmeier, Guido}}, issn = {{2574-0970}}, journal = {{ACS Applied Nano Materials}}, pages = {{831--843}}, title = {{{Dependance of Poly(acrylic acid) Interfacial Adhesion on the Nanostructure of Electrodeposited ZnO Films}}}, doi = {{10.1021/acsanm.8b02091}}, year = {{2019}}, } @article{22832, author = {{Meinderink, Dennis and Orive, Alejandro Gonzalez and Ewertowski, Simon and Giner, Ignacio and Grundmeier, Guido}}, issn = {{2574-0970}}, journal = {{ACS Applied Nano Materials}}, pages = {{831--843}}, title = {{{Dependance of Poly(acrylic acid) Interfacial Adhesion on the Nanostructure of Electrodeposited ZnO Films}}}, doi = {{10.1021/acsanm.8b02091}}, year = {{2019}}, } @article{25908, abstract = {{Herein we present a new proton-conducting iron(II) metal–organic framework (MOF) of an unusual structure formed by chains of alternating bistriazolate-p-benzoquinone anions and iron(II) cations with four axially coordinated water molecules. These chains assemble via π–π stacking between the aromatic units to form a three-dimensional grid-like network with channel pores filled with water molecules. The material was structurally characterized by single-crystal XRD analysis, and its water and thermal stability was investigated. The proton conductivity was studied by impedance measurements on needle-like single crystals. A simple but efficient measurement setup consisting of interdigital electrodes was used. The influence of the crystal orientation, temperature, and humidity was investigated. The iron(II)-MOF showed the highest proton conductivity of 3.3·10–3 S cm–1 at 22 °C and 94% relative humidity. Contrary to most known structures, the conductivity in this material is controlled by chemical properties of the pore system rather than by grain boundaries. The presented material is the starting point for further tailoring the proton-conducting properties, independent of morphological features which could find potential applications as membrane materials in proton-exchange membrane fuel cells.}}, author = {{Bunzen, Hana and Javed, Ali and Klawinski, Danielle and Lamp, Anton and Grzywa, Maciej and Kalytta-Mewes, Andreas and Tiemann, Michael and von Nidda, Hans-Albrecht Krug and Wagner, Thorsten and Volkmer, Dirk}}, issn = {{2574-0970}}, journal = {{ACS Applied Nano Materials}}, pages = {{291--298}}, title = {{{Anisotropic Water-Mediated Proton Conductivity in Large Iron(II) Metal–Organic Framework Single Crystals for Proton-Exchange Membrane Fuel Cells}}}, doi = {{10.1021/acsanm.8b01902}}, year = {{2019}}, } @article{25906, abstract = {{A composite material of copper oxide (CuO) dispersed in the nanopores of KIT-6 silica (SiO2) is used as a dosimetric sensor for the detection of hydrogen sulfide (H2S) gas in low parts per milion concentrations. The sensor principle is based on the reversible chemical conversion of CuO to CuS, which guarantees a high selectivity, and on the corresponding percolation-induced change in electronic conductance.}}, author = {{Paul, Andrej and Weinberger, Christian and Tiemann, Michael and Wagner, Thorsten}}, issn = {{2574-0970}}, journal = {{ACS Applied Nano Materials}}, pages = {{3335--3338}}, title = {{{Copper Oxide/Silica Nanocomposites for Selective and Stable H2S Gas Detection}}}, doi = {{10.1021/acsanm.9b01004}}, year = {{2019}}, } @article{25913, abstract = {{Ordered mesoporous CMK-5 carbon exhibits two distinct pore systems that can be modified individually. This work demonstrates how one of the pore systems can be selectively filled with elemental sulfur, while the other pore system remains empty. The resulting sulfur–carbon composite material with high residual porosity can be used as the cathode material in lithium–sulfur battery cells. We present a systematic investigation of the loading of CMK-5 carbon with variable relative amounts of sulfur and compare the results to the preparation of SnO2 (as well as TiO2, Mn2O3/Mn3O4, NiO) nanoparticle-loaded CMK-5 carbon.}}, author = {{Weinberger, Christian and Ren, Sai and Hartmann, Marc and Wagner, Thorsten and Karaman, Didem. Ş. and Rosenholm, Jessica M. and Tiemann, Michael}}, issn = {{2574-0970}}, journal = {{ACS Applied Nano Materials}}, pages = {{455--462}}, title = {{{Bimodal Mesoporous CMK-5 Carbon: Selective Pore Filling with Sulfur and SnO2 for Lithium Battery Electrodes}}}, doi = {{10.1021/acsanm.7b00307}}, year = {{2018}}, }