TY - CONF AB - One of the main objectives of production engineering is to reproducibly manufacture (complex) defect-free parts. To achieve this, it is necessary to employ an appropriate process or tool design. While this will generally prove successful, it cannot, however, offset stochastic defects with local variations in material properties. Closed-loop process control represents a promising approach for a solution in this context. The state of the art involves using this approach to control geometric parameters such as a length. So far, no research or applications have been conducted with closed-loop control for microstructure and product properties. In the project on which this paper is based, the local martensite content of parts is to be adjusted in a highly precise and reproducible manner. The forming process employed is a special, property-controlled flow-forming process. A model-based controller is thus to generate corresponding correction values for the tool-path geometry and tool-path velocity on the basis of online martensite content measurements. For the controller model, it is planned to use a special process or microstructure (correlation) model. The planned paper not only describes the experimental setup but also presents results of initial experimental investigations for subsequent use in the closed-loop control of α’-martensite content during flow-forming. AU - Arian, Bahman AU - Homberg, Werner AU - Riepold, Markus AU - Trächtler, Ansgar AU - Rozo Vasquez, Julian AU - Walther, Frank ID - 23465 KW - Flow-forming KW - Spinning KW - Process Strategy KW - Martensite Content KW - Property Control KW - Micromagnetic Measurement KW - Metastable Austenitic Stainless Steel SN - 978-2-87019-302-0 TI - Forming of metastable austenitic stainless steel tubes with axially graded martensite content by flow-forming ER -