TY - GEN AU - John, Thomas AU - Kundisch, Dennis ID - 2752 T2 - Pre-ECIS Workshop on the Digitization in Business Models and Entrepreneurship (DiBME) TI - Business Model Representations: A Cross-Disciplinary Review of the Pragmatic, Semantic and Syntactic Foundations of Existing Approaches ER - TY - JOUR AB - Because of widespread irregular lunch consumption by both children and adults, information on the effects of lunch on short-term cognitive functioning is relevant to public health. In September 2012, a MEDLINE search was conducted for studies in which the effects of lunch on cognitive performance were examined. Eleven experimental studies published from 1981 to 1996 were found and evaluated; all involved adults. In three studies, the effects of lunch and lunch skipping were compared; the remaining studies involved a determination of the effects of lunch size and lunch composition. Results of studies in which lunch was compared with no lunch indicate that lunch leads to potential impairment of some aspects of cognitive functioning in the early afternoon. Lunch size may influence cognitive functioning, with impairment more likely to occur after a large lunch than a small lunch. Furthermore, in comparison with low-fat lunches, high-fat lunches seem to result in slower but more accurate responses to some cognitive tasks. However, these suggestions must be viewed with caution, as they are based on only a few studies and are not thoroughly supported by high-quality evidence. In addition, results obtained with adults are not applicable to children. Thus, the potential effects of lunch need further examination in children and adults. AU - Müller, Katrin AU - Libuda, Lars AU - Terschlüsen, Anna Maria AU - Kersting, Mathilde ID - 27524 JF - Canadian Journal of Dietetic Practice and Research SN - 1486-3847 TI - A Review of the Effects of Lunch: On Adults’ Short-term Cognitive Functioning ER - TY - CONF AU - Mutter, Tobias ID - 2753 T2 - Proceedings of the 21st European Conference on Information Systems (ECIS) TI - Do Non-Monetary Incentive Systems Matter? Evidence From the Restructuring of a Non-Monetary Incentive System in an Online Community ER - TY - GEN AU - John, Thomas AU - Weskamp, Christoph AU - Kundisch, Dennis AU - Suhl, Leena ID - 2754 T2 - Pre-ECIS Workshop on the Digitization in Business Models and Entrepreneurship (DiBME) TI - Towards an Agile Simulation-based Method for Creating, Evaluating and Selecting Business Models ER - TY - CONF AU - Kundisch, Dennis AU - Herrmann, Philipp AU - Whittaker, Michael AU - Neumann, Jürgen AU - Magenheim, J. AU - Reinhardt, W. AU - Beutner, Marc AU - Zoyke, A. ID - 2755 T2 - Proceedings of the Design Science Research in Information Systems and Technologies 2013 (DESRIST) TI - Designing a Web-Based Classroom Response System VL - 7939 ER - TY - CONF AU - Herrmann, Philipp AU - Kundisch, Dennis AU - Rahman, Mohammad ID - 2756 T2 - Proceedings of the 46th Hawaii International Conference on System Sciences (HICCS) TI - Does it Pay Off to Bid Aggressively? An Empirical Study VL - 46 ER - TY - JOUR AU - Mesch, C. AU - Stimming, M. AU - Wagner, A. AU - Libuda, Lars AU - Kersting, M. ID - 27581 JF - Ernährungsumschau International TI - Rekrutierung von Müttern mit Säuglingen in einer Interventionsstudie – erste Erkenntnisse aus der PINGU-Studie. VL - 7 ER - TY - THES AU - Schröder , Cathrin ID - 27697 TI - Verfahrenstechnische Entwicklung zum Hinterspritzen von Echtholzfurnieren mit Wood-Plastic-Composites (WPC) ER - TY - THES AU - Hallmann, Tobias ID - 27698 TI - Untersuchung des Prozessverhaltens neuartiger Einzugzonen-Konzepte für Kautschukextruder ER - TY - JOUR AU - Assmann, K.E. AU - Joslowski, G. AU - Buyken, Anette AU - Cheng, G. AU - Remer, T. AU - Kroke, A. AU - Günther, A.L.B. ID - 27732 JF - Obesity SN - 1930-7381 TI - Prospective association of protein intake during puberty with body composition in young adulthood ER - TY - JOUR AU - Günther, Anke L. B. AU - Walz, Helena AU - Kroke, Anja AU - Wudy, Stefan A. AU - Riedel, Christina AU - von Kries, Rüdiger AU - Joslowski, Gesa AU - Remer, Thomas AU - Cheng, Guo AU - Buyken, Anette ID - 27733 JF - PLoS ONE SN - 1932-6203 TI - Breastfeeding and Its Prospective Association with Components of the GH-IGF-Axis, Insulin Resistance and Body Adiposity Measures in Young Adulthood – Insights from Linear and Quantile Regression Analysis ER - TY - THES AB - Reconfigurable circuit devices have opened up a fundamentally new way of creating adaptable systems. Combined with artificial evolution, reconfigurable circuits allow an elegant adaptation approach to compensating for changes in the distribution of input data, computational resource errors, and variations in resource requirements. Referred to as ``Evolvable Hardware'' (EHW), this paradigm has yielded astonishing results for traditional engineering challenges and has discovered intriguing design principles, which have not yet been seen in conventional engineering. In this thesis, we present new and fundamental work on Evolvable Hardware motivated by the insight that Evolvable Hardware needs to compensate for events with different change rates. To solve the challenge of different adaptation speeds, we propose a unified adaptation approach based on multi-objective evolution, evolving and propagating candidate solutions that are diverse in objectives that may experience radical changes. Focusing on algorithmic aspects, we enable Cartesian Genetic Programming (CGP) model, which we are using to encode Boolean circuits, for multi-objective optimization by introducing a meaningful recombination operator. We improve the scalability of CGP by objectives scaling, periodization of local- and global-search algorithms, and the automatic acquisition and reuse of subfunctions using age- and cone-based techniques. We validate our methods on the applications of adaptation of hardware classifiers to resource changes, recognition of muscular signals for prosthesis control and optimization of processor caches. AU - Kaufmann, Paul ID - 11619 SN - 978-3-8325-3530-8 TI - Adapting Hardware Systems by Means of Multi-Objective Evolution ER - TY - JOUR AB - In the current work, we study the silver ion release potential and the water uptake through a SiOxCyHz-polymer which is grown from the precursor hexamethyldisiloxane (HMDSO) in radiofrequency (RF) plasma. These layers were deposited on top of two dimensional (2D) ensembles of silver nanoparticles (AgNPs) with nominal thickness of 2 nm on a 20 nm RF-sputtered polytetrafluoroethylene (PTFE) thin film. The composition of the plasma-polymerized HMDSO barriers was varied by changing the oxygen flow during the polymerization process and their thickness was varied as well. Morphology and optical properties of the nanocomposites were investigated using transmission electron microscopy (TEM) and UV-Visible spectroscopy (UV-Vis), respectively. The concentration of the silver ions released from the nanocomposites after immersion in water for several time intervals was measured using inductively coupled plasma mass spectrometry (ICP-MS). Contact angle analysis and electrochemical impedance spectroscopy (EIS) measurements were also performed and results show a strong dependence of the coatings properties and their water uptake on the oxygen content in the coating films and their thickness. Plasma polymerization with increasing the oxygen flow leads to the formation of more hydrophilic thin films with a higher Ag ion release potential. Increasing the thickness of the coatings reduced the amount of the released ions and the rate of the release process was slowed down. This indicates that by tailoring the structure and the thickness of the plasma-polymerized coating films, one can tune the silver ion release properties of Ag/polymer nanocomposites. AU - Alissawi, N. AU - Peter, T. AU - Strunskus, T. AU - Ebbert, Christoph AU - Grundmeier, Guido AU - Faupel, F. ID - 20946 IS - 11 JF - JOURNAL OF NANOPARTICLE RESEARCH SN - 1388-0764 TI - Plasma-polymerized HMDSO coatings to adjust the silver ion release properties of Ag/polymer nanocomposites VL - 15 ER - TY - GEN AU - Daun, Marian AU - Fockel, Markus AU - Holtmann, Jörg AU - Tenbergen, Bastian ID - 20973 TI - Goal-Scenario-Oriented Requirements Engineering for Functional Decomposition with Bidirectional Transformation to Controlled Natural Language. Case Study "Body Control Module" ER - TY - GEN AU - Hüwe, Marcus ID - 20978 TI - Das Verteilungsproblem für mechatronische Systeme ER - TY - CONF AB - Das Thema Elektromobilität hat in der Fahrzeugindustrie in den letzten Jahren viel Aufmerksamkeit erhalten. Gerade im Bereich der Entwicklung von Steuergeräte-Software ist der Bedarf an frühzeitiger Absicherung hoch. Nur so können Produkteinführungszeiten minimiert und effektiv Entwicklungskosten eingespart werden. Komplexe Werkzeugketten und die verteilte Entwicklung erschweren den Prozess und verlängern die Entwicklungszeit. Das Förderprojekt „Simulationsgestützter Entwurf für Elektrofahrzeuge“, kurz „E-Mobil“, nimmt sich der Herausforderungen einer verteilten Entwicklung von Steuergeräte-Software an. Vier Projektpartner aus Industrie und Forschung untersuchen die Besonderheiten sowohl bzgl. des Entwurfsprozesses, als auch der beteiligten Entwurfswerkzeuge im Vergleich zur konventionellen Fahrzeugentwicklung. Im Fokus stehen die Modellierung und die simulationsgestützte Absicherung in frühen Entwurfsstadien. Die Modellierung umfasst Regelungssoftware sowie die für die Simulation nötigen elektrischen und mechatronischen Komponenten. Die vorliegende Arbeit stellt die Kernthemen sowie aktuelle Ergebnisse aus dem Projekt vor. AU - Farshizadeh, Emad AU - Briese, Hermann AU - Steinmann, David AU - Stockmann, Lars AU - Beringer, Steffen AU - Holler, Dominik AU - Klobedanz, Kay AU - Heinzemann, Christian AU - Peter, Klaus AU - Leuer, Michael ID - 20980 T2 - 8. Dortmunder Autotag TI - Simulationsgestützter Entwurf für Elektrofahrzeuge ER - TY - GEN AB - Die in der Automobilindustrie verwendeten eingebetteten Systeme gehören zu den komplexesten eingebetteten Systemen. Die Automobilhersteller sind in der Entwicklung ständig bemüht sowohl die Sicherheit und den Komfort des Fahrers also auch der anderen Insassen zu verbessern. Die meisten der entwickelten Systeme sind sowohl zeit- als auch sicherheitskritisch. Einer Studie von Mercedes-Benz zufolge resultieren 80% der Innovationen in der Automobilbranche aus neuen Elektronikkomponenten, deren Funktionen zu 90% durch Software realisiert wird. Um die steigende Komplexität in der Entwicklung von eingebetteten Systemen zu beherrschen wird in der Automobilbranche immer öfter die modelbasierte Softwareentwicklung anstelle der klassischen Programmierung eingesetzt. Im Requirements Engineering, der ersten Phase der Entwicklung eines Produktes, werden die Anforderungen gesammelt und dokumentiert. Die Dokumentation erfolgt mittels natürlicher Sprache. Modellbasierte Ansätze werden heutzutage höchstens unterstützend eingesetzt. Während des Requirements Engineerings muss der Requirements Engineer sowohl die funktionalen Anforderungen an das zu entwickelnde System als auch seine zeitlichen Anforderungen spezifizieren und analysieren. Die funktionalen Anforderungen umfassen dabei insbesondere die Kommunikation zwischen den verschiedenen Teilsystemen. Szenarien stellen eine intuitive Möglichkeit zur Modellierung von funktionalen Anforderungen dar. Im Rahmen dieser Arbeit wird ein modellbasierter Ansatz zur Modellierung von Szenarien verwendet. Anforderungen an das zeitliche Verhalten werden innerhalb der Architektur spezifiziert. Dazu stehen in der Automobilbranche Architekturbeschreibungssprachen wie EAST-ADL zur Verfügung. Obwohl sowohl funktionale als auch zeitliche Anforderungen an das System spezifiziert und analysiert werden müssen, existiert bisher keine Methodik, die beide Ansätze miteinander kombiniert. Aus diesem Grund wurde im Rahmen dieser Arbeit eine neue Requirements Engineering Methodik entwickelt, die eine systematische und ganzheitliche Spezifikation und Analyse der funktionalen und zeitlichen Anforderungen bereitstellt. Wir haben zwei Modelltransformationen entwickelt, um den Requirements Engineer beim Übergang von den funktionalen zu den zeitlichen Anforderungen zu unterstützen. Die vorliegende Arbeit wird durch eine Evaluierung der Methodik, sowie der Modelltransformationen auf Basis eines Komfortsteuergerätes abgerundet. AU - Koch, Thorsten ID - 20985 TI - Combining Scenario-based and Architecture-based Timing Requirements ER - TY - JOUR AU - Harder, Georg AU - Ansari, Vahid AU - Brecht, Benjamin AU - Dirmeier, Thomas AU - Marquardt, Christoph AU - Silberhorn, Christine ID - 21041 IS - 12 JF - Optics Express SN - 1094-4087 TI - An optimized photon pair source for quantum circuits VL - 21 ER - TY - JOUR AU - Christ, Andreas AU - Brecht, Benjamin AU - Mauerer, Wolfgang AU - Silberhorn, Christine ID - 21042 JF - New Journal of Physics SN - 1367-2630 TI - Theory of quantum frequency conversion and type-II parametric down-conversion in the high-gain regime VL - 15 ER - TY - JOUR AU - Brecht, Benjamin AU - Silberhorn, Christine ID - 21043 JF - Physical Review A SN - 1050-2947 TI - Characterizing entanglement in pulsed parametric down-conversion using chronocyclic Wigner functions VL - 87 ER -