Experimental and numerical investigation of the influence of rolling-induced sheet metal deformation on SPR joints In the development of advanced lightweight automotive solutions, self-piercing riveting (SPR) offers the possibility of joining multi-material structures to fulfil a wide variety of requirements. With regard to the entire process chain, production-related pre-deformations of the parts to be joined can influence the geometric shape and load capacity of SPR joints. Various studies have investigated the influence of pre-stretched sheet materials, in the sense of pre-drawing processes, on the formation of SPR joints. The impact of pre-stretching sheet metals on the formation of their geometrical characteristics and the shear-tensile strength of SPR processes was observed [1]. Pre-rolled semi-finished products are also joined together in mixed material automotive structures, e.g. tailor rolled blanks. This work aims to investigate the influence of pre-rolled joining parts on the geometric formation and load-carrying capacity of SPR joints. For this purpose, sheets of metal are cold-formed using a rolling process to induce a defined strain-hardening state in the material and then joined in various combinations. As the degree of deformation increases, the rolling of samples can lead to minimal accumulation of damage in the sheet materials, which can influence the joint behaviour. The rolling process, as well as the subsequent joining process, are also investigated by FEM. The influence of pre-rolled semi-finished products on the strength of the SPR joints is investigated.</jats:p> 54 Materials Research Forum LLC