Refill friction stir spot and resistance spot welding of aluminium joints with large total sheet thicknesses (III-1965-19)

Refill friction stir spot welding (RFSSW) is a highly flexible and promising solid-state joining method for aluminium alloys. Alternatively, resistance spot welding (RSW) can be stated as an appropriate joining method which can be automated and used within a high-volume production due to short process times. Both processes do not need any additional elements and a flat surface on both sides of the joints can be realised. In order to meet the modern requirements for crash safety and structural stiffness, thermal and mechanical joining methods are mainly combined by using single-component epoxy resin adhesives. Due to an insufficient knowledge about the application of both thermal joining methods for the abovementioned material combinations combined with additional adhesives, deeper investigations were done regarding the interactions of the polymers and the joining processes. Starting with a brief presentation of the boundary conditions of the investigations and the refill friction stir spot welding and resistance spot welding of high-strength aluminium alloys with sheet thicknesses bigger than 5.8 mm, the paper introduces the process-related joint properties of friction-based and resistance-based welded joints. Afterwards, the paper discusses the influences of the process parameter on the metallographic joint formation and load-bearing capacities for a selected two-sheet and four-sheet material combination. When combining the spot welding technologies with adhesives, the process parameters of the RFSSW process have to be adapted for the two-sheet combination by adding a squeeze-out step, while for RSW, just the preholding time has to be increased. Different challenges for both joining methods are shown. For RFSSW, the gap formation has to be considered when welding big total sheet thicknesses, while for RSW, the shape of the weld nugget is more important for an appropriate joint performance. Additionally, process optimisations for less adhesive incineration will be discussed for both joining processes, and the influences of the adhesive on the joint formation will be addressed with the help of load-bearing capacity evaluations. The paper closes with specific recommendations for the realisation of refill friction stir and resistance spot-welded joints with and without adhesive in the field of Al joints with big total sheet thicknesses which meet the quality demands and an outlook for further research steps will be given.